Ericsson Mini Link Cli Commands -

: Instantiates a new broadcast domain/VLAN on the node.

The following are some troubleshooting CLI commands used in Ericsson Mini Link:

Core command categories and representative uses ericsson mini link cli commands

admin> alarms ls

If the hardware was fine, maybe the frequency had drifted or the power was too low. He checked the radio configuration: : Instantiates a new broadcast domain/VLAN on the node

show radio-link detail — Displays current transmit (TX) power, receive (RX) signal level, and modulation status.

: Enabled by the enable command. This mode allows configuration changes . receive (RX) signal level

show running-config — Prints the active configuration directly to the terminal screen.