Test Point New | Mi A0101

On newer board revisions, these two distinct pinheads are isolated away from the main components to prevent accidental shorting with the shield housing. Step 4: Execute the Hardware Short and Connect to PC

The (TP‑A) is located near the eMMC chip on the bottom side of the board.

Once the port appears, carefully remove the tweezers. The phone is now locked in flashing mode. Step 4: Flash the Stock Firmware mi a0101 test point new

Follow these steps carefully to ensure the device enters EDL mode. Step 1: Open Device Manager

With the battery still connected (or disconnected initially, depending on the tool), use the metal tweezers to hold both test points together firmly. Step 3: Connect USB Cable On newer board revisions, these two distinct pinheads

: The system cannot load the OS and continuously restarts on the "Mi" logo.

Select the correct COM port identified in the Device Manager. Click or Flash . The phone is now locked in flashing mode

Before opening up your tablet, gather these essential physical and digital tools:

Check Device Manager on your PC. It should appear under "Ports (COM & LPT)" as Qualcomm HS-USB QDLoader 9008 . Common Troubleshooting

On your computer, open and expand the "Ports (COM & LPT)" section. This allows you to verify if the phone is connected successfully. Step 2: Bridge the Points

They are typically isolated from the main ground shield but sit adjacent to the small flex ribbon cables. Step 3: Trigger EDL Mode