This can occur when reading or writing, often due to poor connection between the programmer and the target chip. Check your wiring and consider using shorter, higher-quality wires. If using a test clip, ensure it is making contact with all pins of the chip.
Standard 25xxx series used extensively in PC BIOS chips and router firmwares. Experimental support for complex high-capacity NAND chips. SPI EEPROMs
: Double-click NeoProgrammer.exe to boot the interface immediately. Step-by-Step Flashing Workflow
It is important to understand the software's version history, as it is a community-driven project with active development.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Installation notes
The primary advantage of this software is its custom protocol handling. It eliminates redundant verification prompts and features an advanced status register editor (SREG), which allows technicians to lift write-protections on stubborn motherboards or graphics card EEPROMs seamlessly. Key Features of the 2.1.0.19 Version
: A clean, no-nonsense GUI that prioritizes speed and functionality.
: Plug your CH341A or compatible programmer into a USB port. Launch Software : Open the NeoProgrammer.exe file.
The standard stock software bundled with cheap CH341A programmers is notoriously plagued by slow read/write speeds, outdated chip databases, and broken translations. NeoProgrammer 2.1.0.19 directly fixes these hurdles.
A: Yes, as of early 2026, new versions of the software are still being released, with updates focusing on chip database expansions and minor bug fixes.
M34E02, AT34C02, M34E04, AT34C04, CT1C08, CT1C16, M35080, M351xx, ST95P08 93Cxx (8/16 bit configuration), 93C57 Microcontrollers (MCU) AVR Mcu (ATmega, ATtiny), NUVOTON Mcu (N76E003), ENE KB90xx
Insert your chip into the programmer ZIF socket or attach the SOP8 test clip to the board. Inside NeoProgrammer, click the button. The software queries the chip's internal JEDEC ID and opens a selection panel showing matching manufacturers and sizes. Step 2: Backup Existing Firmware (Read)
: Click Erase to completely clear the memory registers.
[Connect IC Chip] ➔ [Click "Detect IC"] ➔ [Read & Save Backup ROM] ➔ [Load New File] ➔ [Write/Verify IC] 1. Connect and Identify the Chip