Siemens no longer actively distributes STARTER V5.4 via their public "Support & Downloads" portal as the primary option. However, it remains available:
💡
Click and give your project a descriptive name. sinamics starter v54
Its strength lies in its . There is no hidden PLC logic overriding your commands. There is no compile time. There is no "cloud sync." It is just you, the drive, and the raw parameters.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Siemens no longer actively distributes STARTER V5
Click on or use the Project Wizard for a guided setup. Name your project and specify the storage location. Step 2: Configure the Communication Interface Go to Options -> Set PG/PC Interface .
What (PROFINET, PROFIBUS, etc.) are you utilizing to connect your PC? There is no hidden PLC logic overriding your commands
Select the motor identification type (MotID). Note: For safety, a standstill measurement is recommended on the first run. Step 5: Download and Perform Motor ID Go by clicking the yellow connect icon.
This tool acts like a bridge between your computer and your motor drive. You do not need to look up long code lists on paper. Instead, you can click through clear menus on your screen.
Click the icon to permanently flash your configuration to the drive’s memory card or internal EEPROM.