Connect the positive side of the relay coil directly to the constant +12V rail.
Because the unit is completely sealed to meet , mounting requires careful attention to wire management and surface preparation.
Tecom TS1162 (also known as the 3 LED RAS) is a robust Remote Arming Station (RAS) designed for use with Challenger security systems. Rated ts1162 installation manual exclusive
The keypad has a pre-wired pigtail for connections. For longer runs, extend using 4-core (minimum) shielded cable.
The TS1162 is built for durability in harsh environments, featuring a high resistance to dust and water. IP67 (Dust-tight and waterproof). Connect the positive side of the relay coil
Power up the Challenger control panel. The TS1162 status LEDs will cycle to show it is active but unmapped.
A: That is the exclusive sense pin for the “Live Health Monitoring” feature. Connect it to an analog input (0-10V). The voltage output equals (Internal Temp in °C) x 0.3 + (Vibration in mm/s) . This allows predictive maintenance. Rated The keypad has a pre-wired pigtail for connections
This report provides a structured, step-by-step guide for installing the * TS1162 equipment. While this summary is generalized to avoid copyright concerns, it aligns with typical installation manual frameworks.
The exclusive manual notes that this digital calibration is 10x more accurate than analog trimming and compensates for the specific nonlinearity of your individual TS1162 unit.
Integrates with Challenger panels & Intelligent Access Controllers. RS-485 LAN Bus Supports standard multi-drop topology configurations. Maximum Bus Length Up to 1.5 kilometers (4,921 feet)