Use a USB flash drive formatted to the FAT32 file system. The receiver will not recognize NTFS or exFAT formats. Correct Firmware File: Download the official software specific to the " Starsat SR-X97 USB Titanium Go to product viewer dialog for this item.

Automatically organizes new frequencies and removes dead channels.

After upgrade, perform factory reset if required by the release notes.

Power off device. Insert USB drive.

Ensure the USB is formatted to FAT32, the .bin

Now you are ready to install the new software onto your Starsat SR‑X97 USB Titanium.

firmware file into the root directory (the main folder) of your USB drive.

Standard upgrade procedure (safe path)

To clear lingering configuration conflicts from the old firmware, press -> Setting -> Factory Default -> All . (Default PIN is usually 0000 ). Perform a fresh blind scan to repopulate your channels.

: Before attempting any upgrade, try disconnecting the satellite antenna cable. In some cases, a device in a boot loop will boot up properly without the antenna attached. You can then go into the menu and perform a factory reset or a reinstallation of the firmware.

Verify the firmware version specifically matches the SR-X97 USB Titanium model. Step-by-Step Installation Guide